Set the serial console to ttyS1 in raccoon

Apparently the ttyS0 console doesn't exist but ttyS1 does:

  raccoon% sudo stty -F /dev/ttyS0
  stty: /dev/ttyS0: Input/output error
  raccoon% sudo stty -F /dev/ttyS1
  speed 9600 baud; line = 0;
  -brkint -imaxbel

The dmesg line agrees:

  00:03: ttyS1 at I/O 0x2f8 (irq = 3, base_baud = 115200) is a 16550A

The console configuration is then moved from base to xeon to allow
changing it for the raccoon machine.

m/common/base/boot.nix

@@ -11,12 +11,6 @@
     terminal_output --append serial
   '';
 
-  # Enable serial console
-  boot.kernelParams = [
-    "console=tty1"
-    "console=ttyS0,115200"
-  ];
-
   boot.kernel.sysctl = {
     "kernel.perf_event_paranoid" = lib.mkDefault "-1";
 

m/common/xeon.nix

@@ -3,7 +3,7 @@
   imports = [
     ./base.nix
     ./xeon/fs.nix
-    ./xeon/getty.nix
+    ./xeon/console.nix
     ./xeon/net.nix
   ];
 }

m/common/xeon/console.nix

@@ -5,4 +5,10 @@
     wantedBy = [ "getty.target" ];
     serviceConfig.Restart = "always";
   };
+
+  # Enable serial console
+  boot.kernelParams = [
+    "console=tty1"
+    "console=ttyS0,115200"
+  ];
 }

m/raccoon/configuration.nix

@@ -8,6 +8,12 @@
   # Don't install Grub on the disk yet
   boot.loader.grub.device = "nodev";
 
+  # Enable serial console
+  boot.kernelParams = [
+    "console=tty1"
+    "console=ttyS1,115200"
+  ];
+
   networking = {
     hostName = "raccoon";
     # Only BSC DNSs seem to be reachable from the office VLAN
@@ -21,11 +27,7 @@
 
   # Configure Nvidia driver to use with CUDA
   hardware.nvidia.package = config.boot.kernelPackages.nvidiaPackages.production;
-  hardware.opengl = {
-    enable = true;
-    driSupport = true;
-    setLdLibraryPath = true;
-  };
+  hardware.graphics.enable = true;
   nixpkgs.config.allowUnfree = true;
   nixpkgs.config.nvidia.acceptLicense = true;
   services.xserver.videoDrivers = [ "nvidia" ];